Install Free Gold Price Widget!
Install Free Gold Price Widget!
Install Free Gold Price Widget!
|
- Mega timers - Programming - Arduino Forum
The PWM pins are shown but I can't find which timer controls which PWM output I need to change the PWM frequency of the PWMs I use if needed I need a PWM frequency of about 31kHz and need to setup the appropriate timer control register for that (I use 10 PWMs of the Mega and need to make sure the correct frequency gets to the correct PWM)
- Watchdog timer WDT - prevent esp32 from stucking
i have esp32 and using arduino ide (2 0 18 board version) im trying to add a code that prevent esp from blocking so if it stuck for some reasons to restart it i found following code but is not working #include "esp_task_wdt h" #include <WiFi h> #include <HTTPClient h> Define timeout in seconds (3minutes = 180seconds) #define WDT_TIMEOUT 180 void setup() { esp_task_wdt_init(WDT_TIMEOUT
- FspTimer: using AGT timer issues - UNO R4 Minima - Arduino Forum
Servo test program servo_timer_config: type:1 Channel: 1 Raw Period: 960000 Note: servo_timer get_period_raw() returned a period of 960000 Which does not make sense, as I am pretty sure this is a 16 bit counter Wonder maybe it did not like to do a period that long So tried changing to 1500 Raw Period: 71999 Tried 750 -> 35999 Thoughts?
- Start a timer when button is pressed - Arduino Forum
I am creating a timer for a race I have a photosensor that has a laser pointed to so when someone crosses the finish, it trips the sensor, and the system logs the racer's time I am using millis() to time the race, but I need the timer to start when I push the button I have tried using edge detection to start the timer, but the timer starts when the program starts, not when the program
- Use of Timer 2 in Arduino UNO
Iam beginner with arduino and learning Interrupts , Stuck at a point while doing my project , I want to know how to use timer 2 for interrupt , i wrote a small peace of code , after every 10ms i want to monitor a sensor input
- Timer ISR - Programming - Arduino Forum
Arduino Timer Interrupts: Timer interrupts allow you to perform a task at very specifically timed intervals regardless of what else is going on in your code In this instructable I'll explain how to setup and execute an interrupt in Clear Timer on
- Making a timer - Programming - Arduino Forum
Hello, I am making a Timer with my LCD Display I do not have any input connected at this point in time I am trying to make my timer display count down but I do not know how I can do this I was hoping someone may assist me with the coding of this I have not touched arduino in a while so I am a little dusty
|
|
|