Install Free Gold Price Widget!
Install Free Gold Price Widget!
Install Free Gold Price Widget!
|
- Solved QA2: A closed tank contains compressed air and oil . . . - Chegg
QA2: A closed tank contains compressed air and oil The oil's (SG=0 9) as is shown in Fig A2 A manometer using Mercury (SG= 13 6) is connected to the tank as shown The column heights are h1=72 cm, h2= 12 cm and h3 = 18 cm Determine the pressure reading of the gage
- Solved QA2: A closed tank contains compressed air and oil as - Chegg
QA2: A closed tank contains compressed air and oil as is shown in Fig A2 A manometer using Mercury is connected to the tank as shown Write an equation (expression) for the pressure at the interface between the surface of the oil in the tank and the air in the tank 10 Marks Note: All steps, used in deriving the final expression must be shown
- Q2 Consider the truss shown in Figure QA2. It has - Chegg
It has a mass of 2 439 kg applied at joint "C" and a mass of 1 0 kg applied at joint "G" The trusses have six load cells attached to the struts, as depicted in Figure QA2 by the black rectangles 1-6 The struts are connected through hinges at the joints (a) Construct the Free Body Diagram (FBD) for the entire truss in Figure QA2
- Solved The hemispherical dome as shown in Figure QA2 weighs - Chegg
The hemispherical dome as shown in Figure QA2 weighs 30 kN and is filled with water at 20°C the dome is attached to the floor by six equally spaced bolts (a) Derive the formula for the downward force exerted by air on the dome from the outside [13] (b) Derive the formula for the upward force exerted by water on the dome from the inside
- Solved Question A2 [Note that, the solution for section i is - Chegg
The shaft has an inner diameter of 100mm and an outer diameter of 150 mm Figure QA2 1 a) Determine: The normal stress at point A due to the normal force (N) [2 marks] The polar moment of inertia of the shaft's cross-section (J) [2 marks] # The torsional shear stress due to the torque applied (T) [2 marks] b) If due to the applied loading on
- Solved QA 2 The strain rosette shown in Figure QA2 was used - Chegg
QA 2 The strain rosette shown in Figure QA2 was used to obtain normal strain data at a point on the free surface of a machine part (a) Determine the strain components \\( \\varepsilon x, \\varepsilon_{y} \\), and \\( \\gamma_{x y} \\) at the point [9 marks] (b) Determine the principal strains and the maximum in-plane shear strain at the point
- Solved QA2. Fig. QA2 shows a thin semi-circular bracket, AB, - Chegg
QA2 Fig QA2 shows a thin semi-circular bracket, AB, of radius R is built in at A, and has at B a rigid horizontal arm BC of length R The arm carries a vertical load 'W at C (a) Remembering that the arm BC is rigid, show that the vertical deflection at C is equal to 6, TWR 2EI, where E is the flexural rigidity of the bracket material
- Solved Consider the truss shown in Figure QA2. It has a mass - Chegg
It has a mass of 2 439 kg applied at joint “C” and a mass of 1 0 kg applied at joint “G” The trusses have six load cells attached to the struts, as depicted in Figure QA2 by the black rectangles 1-6 The struts are connected through hinges at the joints (a) Construct the Free Body Diagram (FBD) for the entire truss in Figure QA2
|
|
|