Install Free Gold Price Widget!
Install Free Gold Price Widget!
Install Free Gold Price Widget!
|
- Mast Life and When to Replace It - SailNet Community
A mast generally speaking is not subjected to a huge amount of changing load that would work-harden the material Most of the load on a mast is a compressive load induced by the stay wires, shrouds Those same stays, shrouds serve to fully support the mast section and reduce (almost eliminate) any movement
- Spar vs. mast. Whats the difference? | SailNet Community
The mast of a sailing vessel is a tall spar, or arrangement of spars, erected more or less vertically on the centre-line of a ship or boat Its purposes include carrying sail, spars, and derricks, and giving necessary height to a navigation light, look-out position, signal yard, control position, radio aerial or signal lamp [1]
- creating a tabernacle from a keel stepped mast
The loads, once the mast is down, are comparatively light (50-150 lbs at each support) But having the mast pivot above the deck can easily double the load on the deck and greatly increase the cost of the project by requiring the reinforcement in the deck and the lower portion of the mast (tabernacle) to be much more robust in all directions
- Mast Winch Install Rigging - SailNet Community
Primarily, whether I can just mount them directly to the mast with a mylar sheet or something in-between base and mast Or if I should use a purpose built pad like the Selden 523-042-01 winch pads Presumably if I used the Selden pads I'd attach the pads with the included monel rivets and tef-gel
- hinged mast - SailNet Community
Generally, a mast step-type hinge is limited to smaller boats, due to the size and weight of the spar My boat, which has a 35' 6" mast, has a mast lowering system, but the spar is lowered as a whole, using a series of A-frames instead I can lower or raise the mast using a single control line
- Mast tabernacle project - SailNet Community
The mast has a flat base bolted to it with the matching hinge on one end When the mast is raised it sits squarely on the base, the hinge only keeps it form skidding around, the heavy weight is borne on the bottom plate and transferred down through the compression post A single centered pin will carry the full weight of mast, stays, and wind
- Mast (Climbing)- No Halyards - SailNet Community
The mast loops -- tied around the mast below the lowest inserted slider car -- relieve the weight and make the job easy Think of this as separating the act of lifting from the act of inserting the sliders cars
- j24 Mast boot size - SailNet Community
Hi, I have yet another question My mast boot is torn It is a 1984 J24 I have gone to Kenyon J 24 Mast Components And noted that there are 2 mast boots available My next step was to measure the opening From outside the collar around the hole for the mast I have measured 10 5" I
|
|
|