Install Free Gold Price Widget!
Install Free Gold Price Widget!
Install Free Gold Price Widget!
|
- Have any experience with HWMonitor? - Toms Hardware Forum
Any piece of software might have a glitch with a particular chipset; to me, unless there was some known issue with an HWMonitor and the X79 chipset (doubtful, as one would suspect the software would have been corrected many years ago,as the X79 board was is widely used for the last 8 years), it is (in my opinion) more likely a motherboard sensor sensor path issue (or even a missing sensor that
- [SOLVED] CPUID HWMonitor temps ok? no idea how to read this.
Min (minimum temperature recorded since HWMonitor started) Max (maximum temperature recorded since HWMonitor started) I'm going to assume the temps above are whilst idle low load 30-35 degrees is very cool No issues at all Then under load you will want to keep them below 80 degrees effectively
- Question HwMonitor, CoreTemp, Real Temp Readings VERY Different?
I rolled back my 5 0ghz OC before I installed the new PSU and didnt change it back while I test ran things tonight But I did have it at 5 0ghz 1 35V at 69c in HWMonitor 2 days ago stress testing at 100% CPU load While I was playing Call of Duty I noticed HWMonitor was showing a package temp in the 50s but each Core was showing around 85c
- [SOLVED] Good hardware sensor monitor? - Toms Hardware Forum
Utilities like HWmonitor, Openhardware monitor and Speccy, tend to COMMONLY misreport sensor data, or not report it at all After installation, run the utility and when asked, choose "sensors only" The other window options have some use but in most cases everything you need will be located in the sensors window
- Question - CPU-Z vs Hwmonitor - Toms Hardware Forum
I have the core voltage set to 1 4 in Bios, however Hwmonitor shows 1 225-1 235 when in full load and 1 36-1 37 when in idle, CPU-Z on the other hand shows 1 37 in full load and 1 508-1 528 in idle Which is the real voltage? And is this good behavior of the voltage? I have an 11900k an z590 maximus extreme if it matters
- HWMonitor Readings (CPU temps vs Package temps?) - Toms Hardware Forum
So I just overclocked my FX-6300 to 4 2GHz @ 1 3v (not final, hoping to get it higher), and I did a quick stress test using Prime95 to check out the temps (using HWMonitor), and to make sure it's somewhat stable When I started the test, I quickly found out that I wasn't sure what to look at for
- HWMonitor min, max and value? - Toms Guide Forum
Min = the minimum value during the time HWMonitor has been running Max = the maximum value during the time HWMonitor has been running
- How to read fan on HW Monitor? | Toms Hardware Forum
PWM fans change speed based on temperature load Looking at your temperatures from HWMonitor, your minimum and maximum temperatures are within a few degrees of each other, so the fan doesn't have to change speed much to maintain temperature I'm trying to figure out if the PWM setting is based on the "Package" temperature or the "TMPIN1" reading
|
|
|